Form Seal
Protective coating for wood and concrete forms

Description:
Form Seal is a high performance one component moisture cure urethane
that is ideally suited to coat porous wood or concrete formwork. This abrasion and chemically resistant material forms a tough waterproof film that will preserve the life of wood and concrete forms.

Surface Preparation:
All surfaces must be clean and dry before application. Concrete: Prior to application of Form Seal prepare surface with light dust blast or by acid wash. Rinse thoroughly and allow to dry. Wood: Sand rough wood to a smooth surface. If wood grain rises after the first coat, sand lightly before applying second coat.

Application Instructions:
Apply Form Seal by brush or roller. Two coats are recommended for maximum protection.

First coat: On concrete, thin first coat one to one with solvent (toluene, Xylene). On wood, thinning is not necessary. Allow first coat to cure (typically 2 - 4 hours).

Second coat: For both wood and concrete, apply material directly from container, no thinning is needed. Do not wait more 24 hours to recoat as the first coat will become so hard it will not allow a second coat to stick to it.

Coverage:
300 - 400 sq. ft. per gallon per coat.

Clean Up:
Clean all equipment with solvent immediately after use.

Packaging:
Available in 5-gallon pail and 55-gallon drum.

Storage:
Store indoor at room temperature.

Caution:
Withdraw only the amount of material you intend to use. Close container immediately to prevent contact with air. Do not pour unused material into container. Store unused material separately and use with 24 hours.

Warning! Flammable liquid and vapor. Causes eye irritation. May be harmful if absorbed through the skin. Keep out of the reach of children